-
The Epoch Dual-Output 12V/36V Marine DC-DC Charger charges a separate 12V auxiliary battery and a 36V trolling motor battery from one compatible 12V or 24V starter-battery system while the engine runs. One independent 12V / 10A output supports a house or electronics battery, and a second 36V / 10A output charges the trolling motor battery.
Automatic voltage sensing, independent LiFePO4, lead-acid, or AGM profiles per output, and lithium BMS activation simplify mixed-voltage marine power. The epoxy-filled IP67 enclosure, aluminum housing, and waterproof cooling fan are built for onboard installation, with no NMEA 2000 or proprietary network required.
Key Features
-
Two independent outputs: 12V / 10A and 36V / 10A banks charge separate batteries from one unit.
-
Up to 480W nominal: About 120W on the 12V bank plus 360W on the 36V bank before conversion losses.
-
12V or 24V source: Accepts a compatible starter-battery system within the 13–30VDC input range.
-
Automatic start and stop: 12V source: starts above 13.8V, stops below 13.0V. 24V source: starts above 26.8V, stops below 25.2V.
-
Chemistry per output: Choose LiFePO4, lead-acid, or AGM separately for the 12V and 36V outputs.
-
Lithium BMS activation: Hold the applicable MODE button for about three seconds after selecting LiFePO4.
-
IP67 epoxy-filled enclosure: High ingress protection with an aluminum housing, cooling plate, and waterproof fan.
-
Built-in protection: Short-circuit, reverse-connection, overcharge, and overtemperature protection.
Status Indicators
- Normal charging: POWER solid green, CHARGING solid red.
- Full charge: POWER and CHARGING LEDs solid green.
- Also shows selected battery chemistry and reverse-polarity status.
- Hold MODE for 6 seconds to turn off; short-press MODE to wake.
Installation
- Three pre-wired ring-terminal lead pairs: source input, 12V output, and 36V output (red positive, black negative).
- 250 × 149 × 68mm enclosure with 6.5mm mounting holes; M6 screws recommended.
- Replacement fuses: 15A for the 12V bank and 15A for the 36V bank.
- Never land a black lead on a terminal carrying red leads.
Suitable For:
- Bass boats with a 12V starter, a separate 12V electronics or house battery, and a native 36V trolling motor battery
- Tournament fishing systems charging both auxiliary voltages while the outboard runs
- Boats with a 24V source system and separate 12V and 36V auxiliary batteries
- 12V and 36V LiFePO4, AGM, or lead-acid auxiliary batteries
Please Note: Non-isolated charger: red and black leads within the same cable jacket must connect to the same battery; follow the supplied wiring diagram for polarity, grounding, and fusing.
Please Note: Verify the outboard or vehicle alternator rating, existing loads, cable sizing, fuse protection, and voltage drop before installation; source-side current on a 12V system can be substantial.
Please Note: Supplements but does not replace a full AC dockside recharge and periodic balancing.
Please Note: A 36V battery is not supported as the input source.
Please Note: Battery type cannot be changed while charging; disconnect the output ring terminals before changing MODE.
Please Note: Do not charge LiFePO4 below 0°C / 32°F unless the battery has approved heating or manufacturer permission.
Please Note: IP67 is not permission for submersion; keep the plug and ring terminals protected from rain, snow, and standing water.
Please Note: Not fanless: maintain more than 30mm of clearance and keep the waterproof fan and cooling surfaces unobstructed.
Please Note: Do not connect the 12V output back to the starter battery used as the input source.
-
Specifications
Brand: Epoch Batteries
Product: Dual-Output 12V/36V Marine DC-to-DC Charger | Charge on the Run
Model / SKU: CHG-DC-12V36V
Product type: Two-bank, non-isolated marine DC-to-DC battery charger
Charging banks: 2 independently operating output banks
Supported source systems: Compatible 12V or 24V starter-battery systems
Published DC input range: 13–30VDC
Unsupported input: 36V input batteries are not supported
12V start threshold: Above 13.8V
12V stop threshold: Below 13.0V
24V start threshold: Above 26.8V
24V stop threshold: Below 25.2V
12V output bank: 12V / 10A
36V output bank: 36V / 10A
Approximate nominal output power: 12V bank ≈120W; 36V bank ≈360W; aggregate ≈480W before conversion losses
12V output purpose: Separate 12V auxiliary, house, electronics, or secondary battery
36V output purpose: Separate compatible 36V auxiliary or trolling-motor battery
Same-battery loopback: Do not connect the 12V output back to the starter battery used as the input source
12V bank chemistry modes: 12V LiFePO4, 12V lead-acid, or 12V AGM
36V bank chemistry modes: 36V LiFePO4, 36V lead-acid, or 36V AGM
Mode selection: Separate front-panel MODE controls for the output banks
Mode-change rule: Select before charging; disconnect that bank's output ring terminals before changing chemistry
Lithium BMS activation: Select LiFePO4 and hold the applicable MODE control for approximately 3 seconds
Cold-weather lithium charging: Do not charge below 0°C / 32°F unless the battery has approved heating or manufacturer permission
Automatic source detection: Starts and stops according to detected 12V or 24V source voltage
Idle / hibernation: Enters hibernation after approximately 20 minutes at idle while monitoring input voltage
Manual power control: Hold MODE for 6 seconds to turn off; short-press MODE to wake
Normal charge indication: POWER solid green; CHARGING solid red
Full-charge indication: POWER and CHARGING LEDs solid green
Other indicators: Selected battery chemistry and reverse-polarity status
Input connection: Pre-wired ring-terminal leads; red positive and black negative
12V output connection: Pre-wired ring-terminal leads; red positive and black negative
36V output connection: Pre-wired ring-terminal leads; red positive and black negative
Connection groups: One input pair plus one 12V output pair plus one 36V output pair
Isolation: Non-isolated
Wiring boundary: Red and black leads within the same cable jacket must connect to the same battery
Grounding warning: A black lead must never be connected to a terminal carrying red leads
Network requirement: No published NMEA 2000 or proprietary data-network requirement
Short-circuit protection: Yes
Reverse-connection protection: Yes
Overcharge protection: Yes
Overtemperature protection: Yes
Housing: Aluminum housing with bottom aluminum cooling plate
Cooling: Waterproof cooling fan; not fanless
12V bank replacement fuse: 15A
36V bank replacement fuse: 15A
Ingress protection: IP67; enclosure filled with pure epoxy resin
Working temperature: -20°C to 40°C / -4°F to 104°F
Nominal working temperature: 25°C / 77°F
Product dimensions: 250 × 149 × 68mm / approximately 9.84 × 5.87 × 2.68 in
Mounting holes: 6.5mm
Recommended fasteners: M6 screws appropriate for the mounting surface
Required clearance: More than 30mm; do not block the fan or cooling surfaces
Alternator compatibility: Verify rated output and available charging current after all existing boat loads
Source-side demand: Can be substantial because the two outputs total approximately 480W before conversion losses
Series-built 36V bank: Follow the battery manufacturer's approved charging and balancing method
Dockside charging: DC-to-DC charging supplements but does not replace a full AC recharge
Ingress caution: Do not intentionally submerge; protect ring terminals, cables, and connections
System protection: Use appropriate fusing, disconnects, conductor sizing, grounding, and marine installation practices
-
CHG-DC-36V / CHG-DC-12V36V User Manual
-
Epoch Batteries Limited Warranty
Warranty Period
2-year limited warranty on Epoch-branded chargers (Epoch general warranty terms)
Epoch Batteries-branded products are covered against qualifying defects in materials and workmanship for the applicable warranty period, subject to Epoch's model-specific remedy schedule and the terms of its warranty policy. Epoch-branded chargers carry a 2-year limited warranty and accessories (such as fuel gauges and voltage reducers) a 1-year limited warranty, from the original purchase date.
Registration
Register your battery with Epoch within 90 days of purchase for full warranty coverage. If it is not registered within that time, the warranty period begins from the battery's original manufacturing date. Proof of ownership is required for any claim, and coverage is non-transferable and applies only to the original purchaser.
Remedy
After inspection and testing, Epoch will provide the applicable remedy for a qualifying manufacturing defect: an approved repair, a replacement, or a comparable-product offer according to the model's schedule. Typical repair turnaround is 3–10 business days once the product is received.
Exclusions
Coverage may be denied when a failure is caused by misuse, improper handling, installation or storage, or use outside the product's specifications. Examples include an unsecured battery; loose, corroded or improperly connected terminals; series or parallel connections beyond the manufacturer's recommendations; reverse polarity or short circuits; impact, fire or water submersion; storage above 140°F or below -40°F; prolonged storage fully discharged or batteries left uncharged for more than three months; poor crimps, undersized cables or damaged wiring; opened, modified or tampered products; and use in applications the battery was not designed for, including repeated engine starting on non-cranking models.
Obtaining Warranty Service
Start a claim through the Epoch Batteries Warranty Portal with your model and serial number, proof of purchase, a description of the issue and supporting photos or videos. If approved, Epoch provides an RMA number and packing instructions. Do not ship a product without a valid RMA. The customer arranges and pays for shipment to Epoch, packaged in compliance with lithium battery shipping rules. Epoch Batteries can be reached at 1-888-501-1846 or support@epochbatteries.com.
Visit Epoch's Warranty Page to review the full warranty terms.
-
Shipping is typically through freight carriers and the actual shipping time is contingent on your location and the specific warehouse dispatching your order. Please allow for a 1-3 business day processing period before shipment, and an estimated delivery time of up to 7 business days. Your confirmation email will include delivery details and we will send you a tracking number as soon as one is available. If you ordered several separate items, you may receive multiple tracking numbers. Once the item has been shipped, the freight service will contact you to coordinate the date and time of delivery. If you require any special accommodations during delivery please let us know as soon as possible and let the delivery company know when arranging the appointment.
Typically, orders will be dropped off either curbside or outside your front door or garage. It is your responsibility to bring the order inside or to its final destination and to remove any existing items.
Depending on the item, parts may be shipped in multiple boxes, and assembly may be required. When your order is delivered, please check that you have all pieces of the item and that nothing is damaged. If your order is damaged during transit and external damage is visible, note the damage immediately, write it on the delivery documents, take photos and/or videos, and refuse shipment. If there is no visible external damage, accept the package but note “subject to concealed damage” on the delivery documents. Any damage upon delivery needs to be reported within 24 hours of delivery or you may not be eligible for a refund. For additional information on submitting claims, as well as incorrect item exchanges, and replacements, please see our Refund Policy.
For more information about shipping, please visit our complete Shipping Policy.
-
Why Shop With Eco Emperor?
At Eco Emperor, our mission is to empower you to lead a sustainable and fun lifestyle with ease and confidence. Whether you're upgrading your outdoor experience or enhancing your eco-conscious journey, here’s why choosing us is a decision you can feel great about:
Expert and Customized Care
Our knowledgeable and friendly team is here to support you every step of the way. We pride ourselves on providing personalized service and swift responses to ensure a smooth and satisfying experience. Our dedicated team is available via phone, email, and live chat to provide you with prompt and helpful support.
Authorized Retailer of High-Quality, Trusted Products from Leading Brands
We partner with the best brands in the industry to bring you reliable, high-quality products. As authorized retailers, we guarantee authenticity and offer full manufacturer warranties on every item. You can trust that our products are built to last and perform efficiently.
Free & Fast Shipping
We know you’re eager to begin your new products or start your next outdoor adventure. That’s why we prioritize quick, reliable, and free shipping to get your orders to you on time and in perfect condition.
Competitive Pricing
We believe that sustainable living should be accessible to everyone. We offer competitive pricing on all our products, so you can enjoy high-quality eco-friendly solutions and outdoor products without breaking the bank.
Choose Eco Emperor for all your outdoor and eco-friendly product needs, and become part of a movement that’s embracing a more sustainable and adventurous lifestyle.
Thank you for supporting a greener, cleaner future, while enhancing your outdoor experiences and powering your adventures.💚